To ensure that the quality of underground light fixtures (including buried light fixtures) is excellent, there are three main issues when installing underground lights:

1, the wire connection seal to do a good job; generally, we have a special sealed rubber ring and stainless steel firmware at the wiring port of the buried lamp, first the wire (special attention to the wire, please use the three-wire cable) through the rubber ring, and then the stainless steel firmware Tighten to the wire and do not pull out the seal rubber ring.

2. Infiltration of groundwater should be done during construction. Do not let it soak in water (because it is not underwater light)

3, Open the cover after the buried light is installed, cover the light for half an hour (this step is very important)